Home/Dera Ismail Khan

Window film in Dera Ismail Khan

Window film supplied and installed in Dera Ismail Khan by Protek Devices, authorized for 3M, TotalGard and Reflectiv since 2000. Heat, safety and privacy film, specified for Dera Ismail Khan's climate.

On the Indus, at the edge of the plains.

Dera Ismail Khan sits on the west bank of the Indus where the Frontier meets the plains, and the summers are severe.

Work here is planned as a single trip covering survey and installation together.

In short

Protek Devices installs 3M, TotalGard and Reflectiv window film in Dera Ismail Khan. Six to seven hours from Lahore, on the Indus. Commercial work starts with an on-site survey; homes are usually filmed in a single visit.

3
Brands, one installer
71
Films to choose across
0
Recorded installs here
Khyber Pakhtunkhwa plains

What Dera Ismail Khan's climate asks of the glass.

Hot, dry summers on the Peshawar valley floor, with dust that settles on everything and a winter that is mild but genuinely cold at night. Glazing takes both a hard summer solar load and a lot of airborne grit.

What we specify here

High solar rejection for the summer, and a hard-coat surface that survives being cleaned often. Where security is part of the brief, anti-shatter film goes on before the solar film rather than instead of it — the two are not alternatives.

Getting to Dera Ismail Khan

Six to seven hours from Lahore, on the Indus.

We work throughout Pakistan, and the portfolio on this site lags the work — no Dera Ismail Khan install is written up yet. We would rather say that than show you someone else's building and imply it was ours.

Coverage

Across Dera Ismail Khan.

We fit film throughout the city, including Cantt, Circular Road and Tank Road. Nowhere is off the list; these are simply the areas we are asked for most.

Questions

Dera Ismail Khan installs, answered.

How long does the film take to fit?

Most homes are a single day. A commercial facade depends on the area and whether it is being done externally, which needs access equipment — that is established at the survey so you are not surprised by it.

Will the dust damage the film?

Not if the right film is fitted and it is cleaned sensibly. Films carry a hard scratch-resistant coating on the exposed face; what damages them is grit dragged across the surface with a dry cloth. Plenty of water, a soft cloth, no abrasive — that is the whole of it.

Can we have heat control and security on the same glass?

Yes, and it is a common brief here. Either a single film that does both, or an anti-shatter layer with a solar film specified to work with it. The survey decides which, based on the glass and what the building needs to withstand.

Your glass, our next Dera Ismail Khan job.

Tell us what the sun, the street or the security risk is doing to your glass, and we'll tell you which film answers it.