Window film supplied and installed in Dera Ghazi Khan by Protek Devices, authorized for 3M, TotalGard and Reflectiv since 2000. Heat, safety and privacy film, specified for Dera Ghazi Khan's climate.
Dera Ghazi Khan sits on the far side of the Indus against the Sulaiman range, and shares the extreme summer of the lower Indus belt.
Work here is planned as a single trip, with the survey and the installation on the same visit, so it is worth telling us the whole scope when you first make contact.
Protek Devices installs 3M, TotalGard and Reflectiv window film in Dera Ghazi Khan. Around six hours from Lahore, on the west bank of the Indus. Commercial work starts with an on-site survey; homes are usually filmed in a single visit.
Some of the hottest inhabited ground on earth. Jacobabad passes 50°C most summers and the belt through Sukkur, Larkana, Multan, Bahawalpur and Rahim Yar Khan is not far behind. The heat is dry, relentless, and arrives as direct solar load on every west- and south-facing pane.
This is where the top of the range earns its price. External silver and high-rejection ceramic films, applied to the outside face where the glass allows, stop the energy before it crosses the pane rather than after. A light interior film is not a serious answer to a west facade here.
Thermal stress is a genuine risk at these temperatures, particularly on tinted or toughened glass and on panes that are partly shaded. Which side the film goes on is a survey decision, not a preference.
Around six hours from Lahore, on the west bank of the Indus.
We work throughout Pakistan, and the portfolio on this site lags the work — no Dera Ghazi Khan install is written up yet. We would rather say that than show you someone else's building and imply it was ours.
We fit film throughout the city, including Block 1 to 12, Cantt, Jampur Road and Civil Lines. Nowhere is off the list; these are simply the areas we are asked for most.
We do not, finally. We will give you an indicative figure from the glass area and what you want the film to do, then confirm it when the specialist is on site. If the survey changes the number we tell you before any work starts.
Often not. Above about 45°C the useful move is to stop the energy before it crosses the glass, which means an external silver or high-rejection ceramic film on the outside face where the glazing allows. A light interior film on a west facade here will disappoint you.
Thermal stress is a real risk at these temperatures, particularly on glass that is already tinted or toughened, and on panes that are partly shaded through the day. It is exactly why the survey establishes the glass type and which face the film goes on. Getting that wrong is how panes break.
Tell us what the sun, the street or the security risk is doing to your glass, and we'll tell you which film answers it.