Reflectiv INT 510 Fine Curvesdecorative window film

Decorative film from Reflectiv

Fine frosted curves that flow across the glass for a light, elegant privacy pattern. Suits reception glazing, meeting rooms and glass doors.

INT 510 is a frosted pattern of fine, tall lines that wander rather than run straight, closer to reeds than to a stripe. Across a partition it reads as texture instead of as a band, which is why it turns up on reception glazing and meeting-room walls where a hard privacy line would look heavy.

It is one of Reflectiv's patterned films, built as 23 microns of PET with a 13 g/m2 acrylic adhesive on a siliconed PET liner. It goes on the inside face, wants the glass above 5 degrees at fitting, and is rated Euroclass B-s1, d0. Rolls are 1.52 metres wide in 2.5, 5, 10 and 30 metre lengths.

Coverage is partial by design, so treat it as decoration with some screening rather than as privacy. The pattern also runs vertically, which means drops across a long run of glass are planned to keep the lines reading the same way instead of being cut to fit.

Which glass it suits

INT 510 is an inside-face film for ordinary clear glass and makes no special demand on the glazing. Reflectiv specifies its patterned range for glazing that is not in direct sun, so it suits partitions, doors and internal screens better than a sun-struck window. Rolls are 1.52 metres wide, and because the pattern is directional, tall glass is set out as matched drops.

Specifications

Figures are nominal and provided for comparison. Your specialist confirms the final specification and suitability for your glass on a site survey.